How do I setup Ubuntu/Linux's Network manager to selectively route network traffic through the VPN?
Solution 1
For my Cisco Compatible VPN in Ubuntu 9.04 (VPNC), there is a check box to select.
Edit your connections, go to the VPN tab, and edit the VPN configuration.
Go to the IPv4 Settings tab, and in the bottom right is a button "Routes".
Click the button and check the box "Use this connection only for resources on its network"
As others have mentioned, there are text based configuration files one can alter instead of using the GUI. One nice thing about GUIs is that you don't have to memorize all the possible values or worry about spelling
Solution 2
With the advice in the above answers and a bit of searching on my own, I was able to find the answer to my own question.
First, I determined what IP address ranges were being used on the VPN, in my case 192.168.32.*
and 192.168.16.*
. Then I connected to my VPN normally and SSH'ed to a server on the network. I ran route on that machine and got the gateway address and metric being used. Then I added routes for the two IP address ranges to the routes field in the IPv4 settings tab and clicked on "Use this connection only for resources on its network" and "Ignore automatically obtained routes". Then poof like magic it worked.
Solution 3
If you want to do a block edit, export or simply a backup the details are in this folder /etc/NetworkManager/system-connections/
To apply changes if any you should do
sudo NetworkManager stop
sudo NetworkManager start
Elijah
Updated on September 17, 2022Comments
-
Elijah almost 2 years
I'm using Ubuntu 9.04 and I just noticed that ALL of my network traffic is being routed through my VPN. I would like the VPN to route only the traffic hitting servers on the VPN and then connect directly to anywhere else on the internet as needed. The VPN is PPTP VPN that is run using some sort of Microsoft stack.
Results from route command:
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 102-102-152-203 192.168.24.1 255.255.255.255 UGH 0 0 0 wlan0 192.168.24.0 * 255.255.255.0 U 2 0 0 wlan0 link-local * 255.255.0.0 U 1000 0 0 wlan0 default * 0.0.0.0 U 0 0 0 ppp0
-
Mark Amerine Turner almost 15 yearsYou may be able to do something with your routing table. Would you mind running 'route' from your command line when you're connected to the VPN and putting the output up here?
-
-
Timmmm about 13 yearsThank you! I've been trying to do this for ages. I also had to set the "Method" to be "Automatic (VPN) addresses only", and left the DNS servers and search domain blank.
-
cc4re over 10 yearscan you give a reference of how to do it in command line - i mean "Use this connection only for resources on its network"
-
Tarick Welling over 4 years@cc4re seems to me that it is adding
never-default=true
to the[ipv4]
section in ubuntu 18.04