HDMI vs Component vs VGA vs DVI vs DisplayPort

Question

What are the pros and cons of each of these different display adapters and cables?

From what I can understand, HDMI offers the ability to send audio along the same cable as well as the ability to do progressive scan.

I've Googled but I can't seem to find any real answers. Why would someone care to run 1280x1024 over HDMI or DVI instead of VGA? What about component?

All I hear is one is digital and one is analog, but I can't find what that means from a feature/benefit stand point.

Solution 1

The nice thing about Digital (HDMI and DVI) is that it is noise tolerant.

On an analog line, to get a perfect picture the voltage at the receiver would need to match the voltage at the sender. Noise can get in there and distort the signal.

On a digital line, the receiver simply needs to determine if the signal is a 1 or a 0 (high voltage or low voltage).

Because of the noise tolerance in a digital signal, you can buy cheap cable and it will work just as well as the expensive stuff (don't listen to the "Pros" that try and sell you the expensive stuff). You can also run the signal over a long distance without introducing a lot of noise.

Solution 2

Connection Types

There are currently four common ways to connect displays to video cards. Depending on what ports your video card has and what inputs your monitor has, choose whichever one you have available or will work the best for your needs.

• VGA (video graphics array) has been around the longest. VGA is an analog signal, meaning the quality may not be as high as with other cables, especially at high resolutions.

  

• DVI (digital video interface) has been on graphics cards for many years now, but is still very common. Almost all LCD displays have a DVI port. Because DVI is a digital connection, the signal will be higher quality than VGA.

  There are several different types of DVI connectors. They're mostly intercompatible, but not always. DVI-A carries only an analog signal (and is therefore rarely useful). DVI-D carries only a digital signal. DVI-I carries both, and can be used with DVI-VGA adapters. DVI-I connectors are the most versatile, as they can be used for either digital or analog signals as necessary.

  There are also two link modes. Almost all DVI cables are single-link, which supports a practical resolution of up to 1920x1200. Dual-link cables can support resolutions up to 2560x1600, and are typically only used for very high resolution displays. Most (but not all) graphics cards with a DVI output do support dual-link DVI.

  You can verify which type of DVI your GPU, monitor, or cable supports by checking the pins.

  

• HDMI (high definition media interface) is a newer port, but is 100% compatible with digital DVI signals. You can get cheap DVI->HDMI and HDMI->DVI cables and adapters (not converters, because there's nothing to convert). HDMI has the advantage of being able to carry an audio signal, but this only works if your card supports outputting HDMI audio and your monitor has built-in speakers can can receive audio over HDMI.

  

  In 2009, HDMI 1.4 and subsequently 1.4a were introduced, with some significant changes from previous versions. These cables are backwards compatible, but add new features such as improved support for 3D displays, higher resolutions, and Ethernet over HDMI to allow for network connectivity on display devices. Most of these features will not affect the typical user, particularly when connected to a computer monitor, but are worth noting.

• DisplayPort is the newest connector. Typically only newer and high-end monitors tend to have DisplayPort. It's typically best to only use DisplayPort if both your monitor and graphics card support it, or if you have more than 2 monitors. If you have more than 2 displays, ATI graphics cards require that you use DisplayPort connectors for the third and any additional monitors.

  There are converters from DP to DVI, VGA, and other connectors, but they are sometimes less stable than a regular cable connection. To convert DisplayPort to DVI or VGA at resolutions above 1920x1200, you need an active converter, which are typically very expensive and require an external power source as well.

  

• Mini DisplayPort is electronically identical to DisplayPort, but has a smaller connector. It is common on higher end laptops, and is also found on some video cards. Mini DP has the same caveats as normal DisplayPort. Adapters for DisplayPort and Mini DP are not compatible, because of the size difference.

Depending on what connectors you have on your card and monitor and what you need to do, you can decide which of these will work best for your situation.

---

Analog vs. Digital

For the curious, here are some more details about analog vs. digital connections:

VGA is the only analog video connector in common use. An analog video signal is typically sent in three components: red, green, and blue (RGB). The color information is sent as a fluctuating electrical current, and the image quality can be degraded if the signal gets disrupted in some way, such as by interference. This is why with analog cables, the quality of the cable can actually affect the quality of the signal. In analog video cables, the information being transmitted corresponds to actual light values for the monitor to show.

Digital signals, which include HDMI, DVI and DisplayPort, send data as a stream of 1's and 0's represented by pulses of electricity. Rather than having a variable current, only a high and low voltage are sent, corresponding to the binary bits. Interference is less of a concern. Analog cables can theoretically carry information for an infinite resolution, while digital signals are limited by their bandwidth. However, this is rarely ever a problem, and the advantages of digital cables tend to outweigh this possible detriment.

This is just a very general overview. If you want more technical detail about how display connectors work, you may want to read the following articles:

• How computer monitors work (How stuff works)
• Analog Signals (Wikipedia)
• Digital Signals (Wikipedia)
• VGA Connector (Wikipedia)

Solution 3

Don't forget that HDMI and DVI support HDCP, or high definition content protection. It's a kind of DRM that prevents you from playing your HD content at full resolution. When buying these cables, be sure that they support the HDCP. Then again, you can always go with the analog hole...

Also, remember that DVI single link and double link differ in the amount of information that they can carry. DVI single link can carry a resolution of up to 1920x1200, whereas double link can do up to 2560x1600, if my memory serves me correctly. The differences can be seen below:

About the whole digital vs analog thing, here's an anecdote to explain. My monitor once had this nasty pinkish/purplish tone over the entire image, which turned out to be a result of the VGA (analog) cable behind it not being secured properly. A digital cable like HDMI or DVI would be able to bypass this problem, because the 1s and 0s are either there or not, perfectly or not. There can be no semi-working purple mode.

Solution 4

I'm going to add extra information about Display port, especially considering the fact that AMD's Eyefinity puts this technology front and center.

Eyefinity

It basically takes one desktop and scales it to multiple screens. So if the 3x1 Landscape on the top left is three 1920 monitors, then it would show a single Windows desktop with a resolution of 5760x1200.

What makes Display Port different from DVI/VGA/HDMI

Now to achieve this, you'll need to use Display Port. Display Port is a very different technology from DVI/VGA/HDMI.

For one, the Display port has more theoretical bandwitdth. It uses a packet architecture not unlike USB or Ethernet. HDMI/DVI and VGA are more like sound speakers or IDE parallel ports. The three color signal wire pairs run parallel with a clock circuit on the fourth pair. DisplayPort's architecture theoretically allows for far greater potential distances.

The DP components also cost less and also requires less voltage ( 3V vs 5V)), and thus theoretically allow Display port only displays to be thinner than displays with HDMI.

The most exciting feature of Display port is the ability to combine multiple Video/Audio streams (thus allowing displays to daisy chain) and USB and Ethernet

Active and Passive Display Port Dongles

By far the most confusion part of Display Port is the initial confusion about Active and Passive Display Port Dongles. This was most noticable when Eyefinity first came out. To use Eyefinity, you need at least one display using Displayport . . .

Well if you hook up a dongle to the Display Port on the AMD card, then two monitors on the DVI ports, then you should get Eyefinity right??

That depends.

There are two ways for a video card to push a HDMI/DVI signal over display port. The first is what is called an active converter. The video card take the HDMI/DVI and encapsulates the signal using Display Port. When the Active dongle receives the signal, it then sends the HDMI/DVI signal to the monitor.

• Pros
  • You can run a Display Port monitor AND an HDMI signal off that same dongle, along with audio and USB (theoretically).
• Cons
  • More expensive than passive (not as big of a deal with the introduction of single uplink Active dongles)

The second method is to use a passive dongle. There is no chip here. The graphics card detects them as and outputs a HDMI/DVI signal over Display Port. The passive dongle then just clocks it up to the HDMI specs.

The problem here is that the video cards capable of Eyefinity only have two "pipelines" that can push out the older HDMI/DVI signals. Thus if you use a passive dongle, you are really sharing that pipeline with three monitors. For Eyefinity to work, it needs more bandwidth (remember 3x1920 monitors is 5760 across!). Thus that is who one of the three monitors has to be powered using the Display Port "pipeline" (the quotes are because I have no idea what the real name is or what the heck they exactly do).

Note also, Active Dongles may also require a USB port for power. A common issue is plugging into a USB port with unstable power or the computer just outright making the USB port fall asleep! Zzzzzz

More DisplayPort fun!:

http://www.elitebastards.com/index.php?option=com_content&view=article&id=796&catid=16&Itemid=29

http://pcper.com/reviews/Editorial/Eyefinity-and-Me-Idiots-Guide-AMDs-Multi-Monitor-Technologyhttp://en.community.dell.com/dell-blogs/direct2dell/b/direct2dell/archive/2008/02/19/46464.aspx

http://www.edn.com/article/472107-Bridging_the_new_DisplayPort_standard.php

http://www.bluejeanscable.com/articles/whats-the-matter-with-hdmi.htm

Solution 5

HDMI and DVI are the same as far as video is concerned. You can switch between them with a $2 adapter. Both of these are digital formats. VGA and component are analog formats. While this is fine for driving a CRT, there is a definite quality loss when connecting to an LCD, since there is a conversion from digital in the video card to analog on the cable, and back to digital at the LCD.

View more solutions

Comments

[harrymc]

As stated, this question has no meaning : 1280x1024 will display just fine with any/all of the above. Theoretical considerations apart, the real video performance practically depends on so many components in the computer that there is no general answer except "go with the latest technology" even if there will be no discernible difference. The quality of the video card one uses to generate the display and that of the monitor are much more important than the format of the output, converted between analog/digital or not.

[surfasb]

I guess I'm the only one who was looking for Display port info. . .

[Borlan Adel]

Is there no benefit for HDMI instead of DVI besides the audio integration?

[KeithB]

As far as I have been able to figure out, the video signals are exactly the same. I researched this a bit trying to hook up my PS3, which is HDMI, to my TV, which is DVI only. For $5, including shipping, I was able to get a converter.

[Kells]

DVI is HDMI without the audio: hdmi.org/learningcenter/faq.aspx#83

[Nazadus]

Interesting note, I must convert HDMI to DVI or else my TV assumes the HDMI has audio and will ignore other audio inputs.

[Keck]

The video signals "are" exactly the same. In fact, if you were to break open that adaptor, you'd find that the "video wires" from the HDMI port are connected directly to the "video wires" of the DVI. There is no signal difference between DVI-D video and HDMI video, just a differently shaped connector.

[prestomation]

HDMI: Audio DVI: Locks better

[MGOwen]

@T Pops: HDMI is smaller, so that could be one more "advantage".

[Mokubai]

As a side note, while there are DVI<->HDMI adaptors DVI also has the connections for analogue video so DVI->VGA connectors are also quite common to connect a new graphics card to an older monitor.

[uxout]

Good answer, but I'm curious where you get the idea that DisplayPort is unstable. It works great.

[nhinkle]

@Shinrai it works great for displayport-to-displayport. I've heard numerous reports of instability when using various converters. I will update the answer to make that distinction more clear.

[stone]

WOW, now that is an answer.

[uxout]

Fair enough, that makes sense. It's always good advice to Not Use A Converter Unless You Have To™ anyway so I wouldn't have thought of it like that. :)

[Sirex]

on the displayport bit, i have an ati 5450 that takes 1 dvi, 1 vga, and one hdmi at the same time. No displayport needed for the third monitor.

[surfasb]

@Sirex: Yes, we forgot about those cards. You can also include the 5750 in that mix as well.

[Scott Chamberlain]

As for "VGA is the only analog video connector in common use" I would have to disagree, Component Video is still fairly common. Perhaps not in PC's but definitely in consumer electronics.

[A.M.]

False: "Because DVI is a digital connection, the signal will be higher quality than VGA.". -- True: "VGA is an analog signal, meaning the quality may not be as high as with other cables, especially at high resolutions." (both from this answer, emphasis mine)

[A.M.]

There is not a "definite quality loss" with analog video. There is a possible quality loss. I have tested VGA against DVI for a HD monitor and seen zero difference. The only cable type I have ever had image problems with is HDMI (black screen or random green checkers).