Server 2008 Std. Audio and Video very choppy on termials

Question

I have a server running Server 2008 std. and about 10 Wyse C10le that connect to it via RDP. My users are complaining about poor streaming quality and choppy video/audio. Is there anything I can do to increase the quality? I have looked into this and found octoshape, but have not been able to find much on what it does?

Solution 1

UPDATE: After MUCH searching I finally found the answer to this freaking problem. Here is the link: http://www.cyberciti.biz/faq/windows-2003-2008-enable-audio-over-rdp/

And the text just in case the post is removed:

To enable sound to be delivered from a 2k8 server (virtual or not, and with or without TS role installed) to any RDP client, the following steps are needed.

1. Change the properties of the Windows Audio service on the 2k8 box so that it’s start mode is “Automatic”. Do the same for the Windows Audio Endpoint service. Start both services. This is probably already done if the box is a physical one and a sound card is installed. It won’t already be done if the box is a virtual.

2. Log out and back in. You will now be presented with a different error on your speaker Icon “No Audio Output Device is installed”. This is because RDP exports your sound card, but not your speaker connections and by default, the audio subsystem requires at least one device connected before it enables the audio functions (how f**stupid is that!)

3. Make a ton of registry changes (repetitive and redundant, but necessary) a. run regedit and locate the following key. You must be logged in as an Administrator to do this: HKEY_CLASSES_ROOT\AudioEngine\AudioProcessingObjects it will contain several subkeys each named with a GUID b. for each subkey: Click on the subkey. Then right click and select “Permissions”. Click on the Advanced button, then click on the “Owner Tab”. The current owner will show as “TrustedInstaller”. Select your Administrative account or group from the list, and click OK to change the ownership. Select the account you just gave ownership to (Administrator or the administrative group), and click on the “Full Contol” checkbox, then click OK. In the detail box, double click on the DWORD value MinOutputConnections. Change the value from 1 to 0 and click OK. Repeat for each and every subkey in the group.

Solution 2

You could try and move the Server to use 2008 R2 with RDS. This should allow you to utilize Remote FX, which delivers video much better. You will probably however have to buy some specific cals for your users.

http://technet.microsoft.com/en-us/library/ff817578%28WS.10%29.aspx

Comments

[msindle]

Couradical, thank you for your response, I changed the SystemResponsiveness to 20 (it was set at 100) and I also changed the NetworkThrottlingIndex to ffffffff (wide open). I'll reboot the server and we'll see how it works tomorrow morning.

[msindle]

The changes I made earlier do not seem to have made a difference. Does anyone have any more suggestions?