Megaraid Firmware fault
7,659
It turned out to be Hardware problem. The Cache attached to the controller was faulty. After replacing the DIMM it issue got resolved.
Related videos on Youtube
04 : 00
MegaRaid WebBios Configuration Step by Step
08 : 30
Raid 5 hard drive failure replacement through megaraid storage manager tool
10 : 38
MegaRAID Storage Manager used to update 9265-8i to 23.4.1-0028 for CacheCade Pro 2.0
15 : 26
How to recover H710 with F/W is in Fault State
01 : 17
DevOps & SysAdmins: Megaraid Firmware fault
Author by
chandank
Updated on September 18, 2022Comments
-
chandank almost 2 years
After building a new server (IBM X3550). Getting error
Firmware is in Fault state: MFI register state 0xF0FF2102. -- For this one could not get any help in google.
And on the BIOS system setting getting the message:
Driver Health Protocol: Missing configuration requires changes setting F1. -- now for this error I went to IBM site and it does not say much only says "Set the appropriate settings'.
I know this is most likely an hardware problem, but still I wanted to know about it.
-
Stilez almost 8 yearsThis turned out to be the correct answer for a similar message with my megaRAID card as well - FW fault 0xFFFFFFFF and boot loop. The battery (or battery board) for the Cache was dud, removing it from the RAID card immediately resolved the boot loop. The above Q and answer helped identify the issue
