Wi-Fi on Ubuntu 20.04 is very slow

11,046

I had similar behaviour on my Lenovo L13 Yoga. Same Network controller, same kernel.

 $ lspci | grep Network
 00:14.3 Network controller: Intel Corporation Wireless-AC 9462

 $ uname -r
 5.4.0-33-generic

I found a temporary fix: I downloaded the firmware directly from Intel: https://www.intel.de/content/www/de/de/support/articles/000005511/network-and-i-o/wireless-networking.html put it in /lib/firmware .

At each reboot I have to restart the wireless:

 sudo modprobe -r iwlwifi
 sudo modprobe iwlwifi

but after doing that wi-fi is working properly.

Share:
11,046
Galactus
Author by

Galactus

Updated on September 18, 2022

Comments

  • Galactus
    Galactus over 1 year

    I am using Ubuntu 20.04 dual boot with windows 10 on Dell Inspiron 13 7000 2-in-1 laptop.

    Wi-Fi speeds in Ubuntu are very slow, whereas in Windows they are good. I checked the Wi-Fi signal. It is strong.

    00:14.3 Network controller: Intel Corporation Wireless-AC 9462
            Subsystem: Intel Corporation Wireless-AC 9462
            Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
            Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
            Latency: 0
            Interrupt: pin A routed to IRQ 16
            Region 0: Memory at 602311c000 (64-bit, non-prefetchable) [size=16K]
            Capabilities: [c8] Power Management version 3
                    Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
                    Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
            Capabilities: [d0] MSI: Enable- Count=1/1 Maskable- 64bit+
                    Address: 0000000000000000  Data: 0000
            Capabilities: [40] Express (v2) Root Complex Integrated Endpoint, MSI 00
                    DevCap: MaxPayload 128 bytes, PhantFunc 0
                            ExtTag- RBE- FLReset+
                    DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq-
                            RlxdOrd+ ExtTag- PhantFunc- AuxPwr+ NoSnoop+ FLReset-
                            MaxPayload 128 bytes, MaxReadReq 128 bytes
                    DevSta: CorrErr- NonFatalErr- FatalErr- UnsupReq- AuxPwr+ TransPend-
                    DevCap2: Completion Timeout: Range B, TimeoutDis+, NROPrPrP-, LTR+
                             10BitTagComp-, 10BitTagReq-, OBFF Via WAKE#, ExtFmt-, EETLPPrefix-
                             EmergencyPowerReduction Not Supported, EmergencyPowerReductionInit-
                             FRS-
                             AtomicOpsCap: 32bit- 64bit- 128bitCAS-
                    DevCtl2: Completion Timeout: 16ms to 55ms, TimeoutDis-, LTR+, OBFF Disabled
                             AtomicOpsCtl: ReqEn-
            Capabilities: [80] MSI-X: Enable+ Count=16 Masked-
                    Vector table: BAR=0 offset=00002000
                    PBA: BAR=0 offset=00003000
            Capabilities: [100 v1] Latency Tolerance Reporting
                    Max snoop latency: 0ns
                    Max no snoop latency: 0ns
            Capabilities: [164 v1] Vendor Specific Information: ID=0010 Rev=0 Len=014 <?>
            Kernel driver in use: iwlwifi
            Kernel modules: iwlwifi
    

    Adding dmesg o/p:

    $sudo dmesg | grep -i iwl
    [sudo] password for ayalar: 
    [    2.414470] Loading modules backported from iwlwifi
    [    2.414470] iwlwifi-stack-public:master:8324:9176b151
    [    2.474032] iwlwifi 0000:00:14.3: enabling device (0000 -> 0002)
    [    2.479041] iwlwifi 0000:00:14.3: Direct firmware load for iwl-dbg-cfg.ini failed with error -2
    [    2.479328] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-55.ucode failed with error -2
    [    2.479458] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-54.ucode failed with error -2
    [    2.479476] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-53.ucode failed with error -2
    [    2.479495] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-52.ucode failed with error -2
    [    2.479510] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-51.ucode failed with error -2
    [    2.479635] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-50.ucode failed with error -2
    [    2.479650] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-QuZ-a0-jf-b0-49.ucode failed with error -2
    [    2.481494] iwlwifi 0000:00:14.3: TLV_FW_FSEQ_VERSION: FSEQ Version: 43.2.23.17
    [    2.481695] iwlwifi 0000:00:14.3: loaded firmware version 48.4fa0041f.0 QuZ-a0-jf-b0-48.ucode op_mode iwlmvm
    [    2.481716] iwlwifi 0000:00:14.3: Direct firmware load for iwl-debug-yoyo.bin failed with error -2
    [    2.551506] iwlwifi 0000:00:14.3: Detected Intel(R) Wireless-AC 9560, REV=0x354
    [    2.704999] iwlwifi 0000:00:14.3: base HW address: 5c:80:b6:a8:67:9a
    [    2.937081] iwlwifi 0000:00:14.3 wlp0s20f3: renamed from wlan0
    

    Kernel:

    $ uname -r
    5.4.0-33-generic
    
    • Twilight
      Twilight almost 4 years
      have you checked if your using the open source WiFi driver? The closed source drivers are usually faster.
    • chili555
      chili555 almost 4 years
      Please edit your question to show the result of the terminal command: dmesg | grep iwl
    • Galactus
      Galactus almost 4 years
      @chili555 i have added the dmesg o/p to the question. i remeber download propertiery blob when i was using 19.04 and then upgraded to 20.04. wifi speed was optimum on 19.04
  • njoye
    njoye almost 4 years
    Dropping the unarchived folder into /lib/firmware did it for me - thanks!
  • Sambhav Gore
    Sambhav Gore over 3 years
    thanks, this is the only solution that worked for me. @njoye is there no alternative to restart wireless after each reboot ?
  • alfx
    alfx over 3 years
    This works and should be the accepted answer. However, in my case no wifi restart is needed.